I just purchased a 15ft. Hobie Power Skiff w/ this motor. The PO never ran the boat and it sat for 4-5 years. I am new to outboards and should have read "Awakening a sleeping outboard; by BoatBuoy" before I put the boat in the water but, too late.
I added fresh fuel and it started right up. I have since ran about ten gallons of fuel through it and after having read "Awakening a sleeping outboard; by BoatBuoy", I realize that there is quite a bit I should have done before running the motor.
Now that it is in the water and I have already ran it what are the items I should do ASAP?
I won't be able to use the boat in the winter due to the lake freezing over so I am hoping to put as much off as I can until then.
The boat was last run at 6000 ft. and I am now at 2500 ft.
The exhaust seems to be darker and more than I would expect. I have been running a richer oil/gas mixture so hopefully that's it.
The real problem I am having is that the boat won't plane.
I am just about to refuel so I will go back to the 50:1 mix and I bought some "Lucas Injector Cleaner" to run through it too.
I also bought a carb rebuild kit that I will install as well.
Any suggestions are appreciated.
I added fresh fuel and it started right up. I have since ran about ten gallons of fuel through it and after having read "Awakening a sleeping outboard; by BoatBuoy", I realize that there is quite a bit I should have done before running the motor.
Now that it is in the water and I have already ran it what are the items I should do ASAP?
I won't be able to use the boat in the winter due to the lake freezing over so I am hoping to put as much off as I can until then.
The boat was last run at 6000 ft. and I am now at 2500 ft.
The exhaust seems to be darker and more than I would expect. I have been running a richer oil/gas mixture so hopefully that's it.
The real problem I am having is that the boat won't plane.
I am just about to refuel so I will go back to the 50:1 mix and I bought some "Lucas Injector Cleaner" to run through it too.
I also bought a carb rebuild kit that I will install as well.
Any suggestions are appreciated.