1995 Mariner 150hp magnum III trbl

[Ronco]

2 Issues to solve????"

1. Have a bad alarm module, where can i find this part???

2. When shifting into reverse, there is a knocking noise before it engages fully????


Thanks for any help!!

 

[nosgsxr]

Re: 1995 Mariner 150hp magnum III trbl

I will have a oil module in a few days. I think they r all the same. I bought one for my merc and then find out it wasnt bad so i now have a new one. Look at the part # on yours and post it so we will know. Then i will post if mine will work

 

[j_martin]

Re: 1995 Mariner 150hp magnum III trbl

Some of them have an extra wire for the water separator, and the lead dress and terminals are different, but I think you can sort out the functions and get any of them (v6) to work right.

Been there once, wasn't too bad.

John

 

[Ronco]

Re: 1995 Mariner 150hp magnum III trbl

Thanks for the reply.. Any ideas on the knocking noise when going into reverse, adjustment issue or ????

 

[j_martin]

Re: 1995 Mariner 150hp magnum III trbl

Thanks for the reply.. Any ideas on the knocking noise when going into reverse, adjustment issue or ????

It's a dog clutch. If you shift slowly it'll clatter, and it isn't good for it. It's designed to smartly clunk into gear.

If you shift smartly, and it clatters, then somethings wrong. Center the shift linkage by taking the cable off, centering the shift lever in the engine by feeling the detent, then with the control handle centered, adjust the cable so it freely drops on. While you're at it check the cable for slop. If it still clatters, you'll have to go into the LU.

hope it helps
John