when attempting to start engine cold:
fuel tank is vented
primer bulb is hard
fuel filter is checked
plugs checked and ok
primer is set to start primed three times and left open
engine starts for 10 seconds then quickly dies
upon trying to restart engine, engine does not seem to start whatsoever, even with all the different choke settings used.
I have been able to start engine, only but pulling on starter rope about 30 times continuously and quickly, leaving the choke OFF, then the engine VERY slowly begins to run faintly, I then put the gear in forward, and the engine starts fine.
after a warmed up engine, it works perfectly.
any solutions? thanks in advanced.
fuel tank is vented
primer bulb is hard
fuel filter is checked
plugs checked and ok
primer is set to start primed three times and left open
engine starts for 10 seconds then quickly dies
upon trying to restart engine, engine does not seem to start whatsoever, even with all the different choke settings used.
I have been able to start engine, only but pulling on starter rope about 30 times continuously and quickly, leaving the choke OFF, then the engine VERY slowly begins to run faintly, I then put the gear in forward, and the engine starts fine.
after a warmed up engine, it works perfectly.
any solutions? thanks in advanced.