Anyone install a jack plate on tracker v14 ( t-h mini jacker or bob's machine mini maual etc...)
I have a 2007 tracker standard guide v14 15" transom with long shaft 1999 f25 hp 4 stroke yamaha. Both only used a few times total while being garage kept. I would rather keep motor knowing what it is then looking for a short shaft. Couple of questions:
1) most of these small jack plate's rate for 40hp but then say 135lbs yami is 141lbs, is this o.k. ?
2) also the boltable area on inside of transom is roughly 10" ( looks like transom goes back in and then down towards last 1" or so on this one)
would any of these fit this application?
3) 2-1/2" offset would be best, but noticed the smaller plates look to be 3-1/2" to 4" offset from transom, would this be o.k.?
Again, thanks for any help in advance
Have a great day
K.C.
I have a 2007 tracker standard guide v14 15" transom with long shaft 1999 f25 hp 4 stroke yamaha. Both only used a few times total while being garage kept. I would rather keep motor knowing what it is then looking for a short shaft. Couple of questions:
1) most of these small jack plate's rate for 40hp but then say 135lbs yami is 141lbs, is this o.k. ?
2) also the boltable area on inside of transom is roughly 10" ( looks like transom goes back in and then down towards last 1" or so on this one)
would any of these fit this application?
3) 2-1/2" offset would be best, but noticed the smaller plates look to be 3-1/2" to 4" offset from transom, would this be o.k.?
Again, thanks for any help in advance
Have a great day
K.C.