Tafflad
Chief Petty Officer
- Joined
- Oct 23, 2007
- Messages
- 544
Just purchased my speed control system - Ridesteady ( Hydrophase | Ridesteady Speed Control for Wakeboarders | )
I need to run some control wires form dash down to engine bay ............
Not had a good look around yet, are there existing ducts ? ..... anybody care to point me to appropriate location.
Also will need to change out Tacho for the Ridesteady control unit, does the dash come out easily, or do I have to do this from underneath ?
Just not done any work on 194FS yet, so appreciate any comments.
n.b. 194FS is same as 204FS
I need to run some control wires form dash down to engine bay ............
Not had a good look around yet, are there existing ducts ? ..... anybody care to point me to appropriate location.
Also will need to change out Tacho for the Ridesteady control unit, does the dash come out easily, or do I have to do this from underneath ?
Just not done any work on 194FS yet, so appreciate any comments.
n.b. 194FS is same as 204FS