Choke solenoid wire help. J60ELCSR

[jcjspringers]

I'm assuming this is the choke solenoid that the wire is shot? Its a single wire that leads back into the wiring harness. I don't like splices but my guess is I'd have to run a new wire all the way back from the switch to the solenoid. Any suggestions would be appreciated. Thanks

 

[TrueNorthist]

Solder a patch of same gauge wire and heat shrink it.

I'm prone to looming wires near the powerhead.

 

[F_R]

?? Looks like the wire is broken off right at the solenoid. There may be no hope for that solenoid.

 

[racerone]

If the wire is still good it looks like an easy fix.---Remove screw at solenoid.---Throw away the short piece of wire and eye.----Splice the correct length wire on and install with new eyelet.

 

[ct1762@gmail.com]

your high speed timing bolt under the flywheel looks like its at 17 degrees or so. these are supposed to be 20 +/1 1 degree just by eyeballing it.

 

[jcjspringers]

Going with a complete new motor cable. Found additional wires that the insulation was crumbling. Not worth my time to splice in a bunch when a new cable is only $100.