Could you guys please check my wiring?

[UWDiver]

I'm getting ready to re-wire a 24' Aquasport. Anyone see any problems?
Thanks for your help!

 

[joey maneri]

Re: Could you guys please check my wiring?

Someone has got to have a better diagram for you, I dont think its gonna help you too much.

 

[Silvertip]

Re: Could you guys please check my wiring?

You have a couple of buss bars -- what are they? Ground or +12V. Agreed that this is not a wiring diagram that would serve any useful purpose. Check the stickies at the top of this page and click the "Generic Boat Wiring Diagram". That diagram takes care of the instrument panel.

Here is a diagram for the switch.

Here is diagram for a switched circuit all the way from the battery to the device:

Here is a diagram for the NAV/ANC circuit (no diode required).

 

[UWDiver]

Re: Could you guys please check my wiring?

The two bus bars are for ground.
I know there are lots of generic diagrams out there but I wanted to do one that was specific to my boat.
I didn't go into specific detail on the dash wiring because it's pretty standard.

 

[Fl_Richard]

Re: Could you guys please check my wiring?

Looks good to me. Where are you bilge pumps connected?

 

[UWDiver]

Re: Could you guys please check my wiring?

Haven't decided yet. Some say directly to the battery, others say through the fuse block at the helm. Thoughts?

 

[madgadget]

Re: Could you guys please check my wiring?

A book on boat electronics I read said use no fuse keep wires short and as neatly protected etc as possible and use no fuse and have no on/off switch except for On/Auto. Makes sense really. The Idea being you cannot leave it off by accident.