Anyone ever troubleshoot this issue before? I can't figure it out. I have the Clymer manual with diagrams but can seem to make sense of where this purple wire is to be connected. It used to flow thru the autoblend unit somehow.
I pulled the Autoblend harness out it had a Black/Purple/Brown. The Purple was a straight connector which routed to the IGN terminal on the Tach. The Gray wire is still connected from the SEND terminal of Tach to the proper terminal on the Rectifier (same spot its always been in). So since disconnecting the autoblend I have no tach. I just dont know what to dowith this purple wire.
Any help from the community here would be great.
THANKS!
Ken
I pulled the Autoblend harness out it had a Black/Purple/Brown. The Purple was a straight connector which routed to the IGN terminal on the Tach. The Gray wire is still connected from the SEND terminal of Tach to the proper terminal on the Rectifier (same spot its always been in). So since disconnecting the autoblend I have no tach. I just dont know what to dowith this purple wire.
Any help from the community here would be great.
THANKS!
Ken