Filling small holes(Picture)

[Zetman]

What would you guys do to fill these holes? I guess the last owner could'nt decide where to mount the transducer and made Swiss Cheese of my transom. Most of the holes are from mounting screws. First I need to figure out how to remove the marine selant. Any suggestions would be nice. Here is a picture

Zet

 

[tashasdaddy]

Re: Filling small holes(Picture)

imho, i would sand it down, fill with dow 5200, and coat with white marine tex. then keep an occasional eye on it.

 

[Zetman]

Re: Filling small holes(Picture)

Tashasdaddy,
When you said "fill with dow 5200" I'm not following that, I checked out Marine tex site and that stuff looks great, also, how do you remove old 5200?
Zet

 

[Coors]

Re: Filling small holes(Picture)

3m makes a remover.

 

[Bondo]

Re: Filling small holes(Picture)

how do you remove old 5200?

I'd Start with a Razor Blade,+ Finish with Sandpaper.......

I'd Probably Skip the 5200,+ go right to the Marine-Tex to fill it back in......

 

[andy6374]

Re: Filling small holes(Picture)

Agreed! If the moon,starts and sun align you might be able to get all the 5200 out. d