All,
As a newbie on this forum as well as new to boat restorations I figured I could get some good advice here
What I have is a 65 Glastron Gulcruiser. The hull appears very solid but the engine/outdrive are unknown. Also the interior is shot
I had planned on attacking the project as follows
1. Gut the interior
2. Remove the engine and outdrive
3. Remove the flooring and check for rot
4. Repair rot as necessary
5. Rebuild engine/outdrive components as required
6. Repair/paint the hull as needed
7. Install rebuilt powerplant and drive
8. Finish the interior
Is this a reasonable approach? Seems so much needs to be done and I am not sure where to start!
Seemed much easier when I restored a few cars
Any thoughts?
-bips
As a newbie on this forum as well as new to boat restorations I figured I could get some good advice here
What I have is a 65 Glastron Gulcruiser. The hull appears very solid but the engine/outdrive are unknown. Also the interior is shot
I had planned on attacking the project as follows
1. Gut the interior
2. Remove the engine and outdrive
3. Remove the flooring and check for rot
4. Repair rot as necessary
5. Rebuild engine/outdrive components as required
6. Repair/paint the hull as needed
7. Install rebuilt powerplant and drive
8. Finish the interior
Is this a reasonable approach? Seems so much needs to be done and I am not sure where to start!
Seemed much easier when I restored a few cars
Any thoughts?
-bips