Fogging for winter question on Fitch

[RendezvousMAN]

I just picked up a 2000 200HP fitch and I am finishing up getting it ready for winter. I have the hood off and I am looking for the threaded cap were I would put the oil into. my other motor had a little red lever next to it but the only thing i can find on this looks like its a air blow out for the water lines. its just a "T" fitting with the cap. this is my first fuel injected motor so the only other thing i was going to do is just spray some fogging oil in each pulg and turn it over a couple times.... I wish i could help with a picture of what i am looking at

 

[boobie]

Re: Fogging for winter question on Fitch

That little "t" fitting should be part of the fuel system to check fuel pressure. Seeing this is your first fuel injected mtr I would recommend you take it into a good BRP dlr and have it done. There are different ways you can do it but the best way is to have a "special mix" you can run through the mtr.