Hello guys! Springs almost here! On my 1972 Chrysler 55 Hp Gear slector box I notice one wire coming from it was not leading to anywhere!
Inside of the box one wire goes to the ignition and the other one was just laying in the back by the engine. The one that goes to the ignition switch when disconnected the engine will not turn over.
The two wires has to prongs coming off of a little toggle that switch up and down on the front of the box next to the neutral start switch. Any ideals.
Inside of the box one wire goes to the ignition and the other one was just laying in the back by the engine. The one that goes to the ignition switch when disconnected the engine will not turn over.
The two wires has to prongs coming off of a little toggle that switch up and down on the front of the box next to the neutral start switch. Any ideals.