Hi everyone. I'm working on a small(ish) center console skiff. New stringers and floor going in. The original did not have a rigging tube for the controls but I would like to put one in from the console to the transom. I'm looking for ideas on how to route the tube, what diameter tube I should use, radius of bends, etc. My primary concern is the radius of any bends in the steering cable. One advantage I have is that it is a wide skiff so there's plenty of room laterally. One disadvantage is that it has a flat bottom so the stringers are only six inches high, leaving not a lot of room under the floor. Any help is appreciated and -of course- pictures would be helpful. Thanks!
