I need to replace my shift cables 170

[cosander]

Is this hard to do? From what I have read I have to remove the sterndrive and pull the cable thru. Am I going to need an alignment tool to finish this project? <br />1986 merc 170

 

[Don S]

Re: I need to replace my shift cables 170

You should check your alignment EVERY time you take the drive off. Plus check the gimbal bearing and visually check everything while it's off.<br />BUT, you do not HAVE to just go change the cable.<br />Here's a link to some HOW TO info you may find helpful.<br /> http://www.mercstuff.com/howdoi.htm

 

[cosander]

Re: I need to replace my shift cables 170

I read that but it didn't go specifically into a step by step (maybe that is asking to much) how to cange the shift cable. After the sterndrive is off is it obvious how to change the cable? I have the manual #8 for the engine but I am looking for a good manual for the drive.

 

[cosander]

Re: I need to replace my shift cables 170

ok I found what I needed on the bellows replacement how to. thanks

 

[cosander]

Re: I need to replace my shift cables 170

will I need this tool? shift cable tool