Jeep Freaks - Seen this before?

[QC]

I hadn't seen this before, and I wasn't even aware of this capability. Was this a goal of the original design? Pretty cool

[video]http://www.youtube.com/watch_popup?v=lgwF8mdQwlw&feature=player_embedded[/video]

What's the thing hanging down in the middle? Skid plate? For what?

 

[oldjeep]

Re: Jeep Freaks - Seen this before?

Its the muffler - wouldn't normally be routed that way

 

[QC]

Re: Jeep Freaks - Seen this before?

I thought muffler, but it didn't come out with the engine and tranny assembly.

 

[JB]

Re: Jeep Freaks - Seen this before?

I have seen contests doing essentially the same thing with beetles. Don't remember the timing.

 

[oldjeep]

Re: Jeep Freaks - Seen this before?

I thought muffler, but it didn't come out with the engine and tranny assembly.

At the end of the dissassembly part of the vid you can see the end that attaches to the exhaust manifold. Looks like they attached the pipe under the trans crossmember

 

[Limited-Time]

Re: Jeep Freaks - Seen this before?

Brake lines? fuel lines? engine coolant? cooling fan? electrical lines?

 

[oldjeep]

Re: Jeep Freaks - Seen this before?

Brake lines? fuel lines? engine coolant? cooling fan? electrical lines?

LOL - There is no radiator in the jeep, but that F-head will put up with a lot - I suspect that they just looped the lines are are running with what fits in the block and hoses. Obviously no brakes, you can see him stop it with the gears - but in low range 1st gear is like brakes. Only need a couple wires to run that motor.

Here's a closer view of one that used to hold down the floor in my garage - damn hard to kill.

 

[Limited-Time]

Re: Jeep Freaks - Seen this before?

LOL - There is no radiator in the jeep, but that F-head will put up with a lot - I suspect that they just looped the lines are are running with what fits in the block and hoses. Obviously no brakes, you can see him stop it with the gears - but in low range 1st gear is like brakes. Only need a couple wires to run that motor.

Here's a closer view of one that used to hold down the floor in my garage - damn hard to kill.

Don't get me wrong. Its still pretty cool. Just kind'a comes from the "why bother section".

 

[Scott Danforth]

Re: Jeep Freaks - Seen this before?

even if its staged, its still cool.

 

[QC]

Re: Jeep Freaks - Seen this before?

Don't get me wrong. Its still pretty cool. Just kind'a comes from the "why bother section".

I kind of agree. Radiator is one of the first things out, just after hood. I was thinking coolant too.

 

[southkogs]

Re: Jeep Freaks - Seen this before?

... that's a pretty common Saturday night in Detroit. About 3AM in Rouge Park when I was growing up.

 

[Jeep Man]

Re: Jeep Freaks - Seen this before?

8 guys times 4 minutes each = 32 minutes. Took me 32 weeks to do mine.

 

[86 century]

Re: Jeep Freaks - Seen this before?

It a neat trick don't see any real value other than being cool.

 

[southkogs]

Re: Jeep Freaks - Seen this before?

It a neat trick don't see any real value other than being cool.

You would have in Korea between 1950 and 1953

From a utility and technology standpoint especially in their day, those jeeps were pretty amazing rigs.

 

[bassman284]

Re: Jeep Freaks - Seen this before?

Seems like there might have been some pre-rigging going on there. It would be interesting to see how long that bad boy would hold together on a rough road at speed.

 

[12vMan]

Re: Jeep Freaks - Seen this before?

Bravo! Very cool staged show, nothing more. I'm sure they welded tabs and had quick release fittings everywhere. Probably only running 3 lugs as well. Possibly still had the emergency brake. It looked like the ignition switch was probably mounted on the back of the motor as he had to reach way down to start it, probably through a big hole in the front of the body below the dash.

 

[puddle jumper]

Re: Jeep Freaks - Seen this before?

that was cool

at first I thought exhaust, but know I am thinking drive shaft tube.