If it is a mixture of water & gear oil in your bilge, the likelyhood of your ujoint bellows being shot is very high........
The good news is that you can do your bellows yourself if you have some tools & mech aptitude.....
The bad news is that you will need to remove your drive & have it resealed by a shop........
If your looking underneath the engine where it attaches to the stern drive. You see two lower bolt...In between there. I hope i'm explaining it properly. It has nothing to do with where it attaches to the boat itself.
Here is a drawing of the inner transom plate. Can you indicate where the water is coming from? Remember, water flows down with gravity , so locate the highest point you see water.
You know Zackman. I read here that someone else has the same problem and it came from the annode block. Do you think that sounds right. Tomorrow i will be going up to the cottage and i will fill the bilge area with water and tilt the trailer so i can see where the water will flow out from. I hope that works. I will keep you posted...Any other ideas will be appreicated.
Thanks
