looking for a merc quicksilver control tach harness

[beretta5spd]

I'm looking for a used harness just like this new one on ebay:

http://www.ebay.com/itm/Telelfex-O-..._Accessories_Gear&hash=item53e165df30&vxp=mtr

Everywhere I look it's around 50 bucks and I can't justify spending that much for a harness for my beater of a boat.
I wouldn't need 10 feet of wiring with it either. Just a foot or so to splice in the wires from my old 3 pin setup.

Attached is a pic of the quicksilver controls. The tach wiring is a 5 pin with all 5 pins located in one half of a circle. The control end has male pins so obviously the harness would have the female end.



EDIT: Deleted solicitation.
Dwight

 

[oldman570]

Re: looking for a merc quicksilver control tach harness

Don't get in a big hurry, I have bought shorter ones new on Ebay for less than $20. Time has a way of rewarding ones that will wait.
Oldman570

 

[1nebel0]

Re: looking for a merc quicksilver control tach harness

all over EBay for $20.00.. I have three at all times in a tote....

 

[oldman570]

Re: looking for a merc quicksilver control tach harness

Check out Ebay
NEW 84-86396A8 WIRING HARNESS ASSY TACH,TRIM,ALARM HORN 84-86396 8
$23.00 + shipping]
Oldman570

 

[marty53]

Re: looking for a merc quicksilver control tach harness

If you are a really cheap SOB like me......... I just use some female crimp on connectors of this type and then jambed them into the harness.
http://cdn.ecolightled.com/images/uploads/bullet_connectors_female_red_500.jpg
Works fine as long as you know which wires are which