i just replaced impeller cause no water was coming out of telltale and then only a little water was coming out so I flushed the motor. Now motor ran for a bit and died and couldnt start it back up. Telltale was still coming out slow. Took off lower unit and there was milky water all over the place. Any ideas?
Also when I tipped up the motor after trying to start there was gas coming out from where the choke is under the cowling. Is this just gas build up because I was trying to start it over an over again or is it possibly not getting fuel properly?
Also when I tipped up the motor after trying to start there was gas coming out from where the choke is under the cowling. Is this just gas build up because I was trying to start it over an over again or is it possibly not getting fuel properly?