Need technical drawing of powertrim pump

[Majozini]

Hi

First excuse me about my poor english. I am from Germany.

I have a Mercury 60 outboard engine from 1985 with powertrim. It is the big pump with is mountetd inside the boat and move two cylinders by 4 hydraulic pipes.
Because of water in oil I disassembled the complete pump. I also opened the small hexagon bolts. Inside there were a lot of springs and balls.

Now I have the problem to rebuild the balls and springs in correct form.

So I need a technical drawing or something else to finish it.

Can me help somebody?
I can post a picture of the pump.

Many greetings from Germany Mario

 

[JUSTINTIME]

Re: Need technical drawing of powertrim pump

post a picture
i might have the manual

 

[Majozini]

Re: Need technical drawing of powertrim pump

Hi Justintime,

I hope you can help me.
I need flow diagramm or a technical dawing that I can see in which borehole the springs and balls are located.

Thank yo very much!

Mario

 

[Majozini]

Re: Need technical drawing of powertrim pump

Hi,

Does nobody have some documentation about this pump???
I need help!

Thanks a lot...

Mario

 

[Majozini]

Re: Need technical drawing of powertrim pump

I need something like the flow chart in the picture below for my pump model!

Thanks again

Mario

 

[MillerTyme]

Re: Need technical drawing of powertrim pump

Did u find anything on that control valve im in the same deal ur in and iv searched every where and nothing so if u did would greatly appreciate it thanks