So i got myself into a little situation today when I installed my new CDI pulse pack. I followed CDI's instructions and removed the clipper circuit but it ran worse then before I replaced it then died altogether. I was thinking it may be the trigger so I am going to try striking the black/white wires per CDI's troubleshooting guide to see what i get at the coil tomorrow.
Here is where I am at now:
Purple wire 12v
Blue wire 9v or 29v cranking (way off from spec)
black/white 8v (both wires)
Is there a way to test the sensor itself? and just out of curiosity what is this pickup optical trigger or some sort of pickup?
Here is where I am at now:
Purple wire 12v
Blue wire 9v or 29v cranking (way off from spec)
black/white 8v (both wires)
Is there a way to test the sensor itself? and just out of curiosity what is this pickup optical trigger or some sort of pickup?