Ray: diagnostic indicator,peak voltage adapter and test harness for 2000 v6 yama

[mclamown]

I would like to know is there anyway to perform the peak voltage test for the charge and pulser coils. Without using adapter or the harness that yamaha shows in the manual. Also is thier anyway to read the codes from the microprosser with out the winky blinky. Thanks Mike

 

[WillyBWright]

Re: Ray: diagnostic indicator,peak voltage adapter and test harness for 2000 v6

Re: Ray: diagnostic indicator,peak voltage adapter and test harness for 2000 v6

You can make a Winky Blinky easy enough. There's nothing complicated about them. I recall that it was explained awhile back. A Search might find it. And you can ohms-check the coils with any multimeter with the leads dicsonnected. I don't have the specs, but if you get resistance, they're probably fine. When they fail, they usually either short-out or break a connection.

 

[Ray Neudecker]

Re: Ray: diagnostic indicator,peak voltage adapter and test harness for 2000 v6

Re: Ray: diagnostic indicator,peak voltage adapter and test harness for 2000 v6

You can't read the codes without a winky blinky. I bought mine on eBay. I have had the hook up harnesses since day one and never thought about any other way. THe charge and pulsor coil is Not a test that has to be done often. Failures there are very rare. You can disconnect the leads and ohm as Willie said. It is a fairly accurate measure on Yamahas as to whether they are good.

 

[mclamown]

Re: Ray: diagnostic indicator,peak voltage adapter and test harness for 2000 v6

Re: Ray: diagnostic indicator,peak voltage adapter and test harness for 2000 v6

You can't read the codes without a winky blinky. I bought mine on eBay. I have had the hook up harnesses since day one and never thought about any other way. THe charge and pulsor coil is Not a test that has to be done often. Failures there are very rare. You can disconnect the leads and ohm as Willie said. It is a fairly accurate measure on Yamahas as to whether they are good.

Thanks for your information that is what I will do. Mike