imported_stump jumper
Seaman
- Joined
- Jul 19, 2006
- Messages
- 71
My boat sunk over the weekend, so assume anything is possible electrically. Everything was working before the boat went down.
Ok, when i connect the trim harness back to the shifter, the motor starts trying to trim. So, the trim switch may have gotten water inside and got screwed up. Why would the motor not trim down now, when using the controls on the motor?
The motor is all the way up and will not trim down. There is power to the pump. Where do I start troubleshooting? Any ideas would be helpful
Ok, when i connect the trim harness back to the shifter, the motor starts trying to trim. So, the trim switch may have gotten water inside and got screwed up. Why would the motor not trim down now, when using the controls on the motor?
The motor is all the way up and will not trim down. There is power to the pump. Where do I start troubleshooting? Any ideas would be helpful
