quintonwatts
Seaman Apprentice
- Joined
- Feb 2, 2013
- Messages
- 33
Hi Chaps
Just coming to the end of an engine rebuild of an AQ205. I am wondering about the tightening torques for the bolts on the clamping ring when putting the flywheel housing back through the transom shield. I have tightened then to 70 NM, but the engineer's manual gives no indication.
Whilst I'm at it, same goes for the engine mounts onto the engine, no torque indicated.
Cheers, Quinton
Just coming to the end of an engine rebuild of an AQ205. I am wondering about the tightening torques for the bolts on the clamping ring when putting the flywheel housing back through the transom shield. I have tightened then to 70 NM, but the engineer's manual gives no indication.
Whilst I'm at it, same goes for the engine mounts onto the engine, no torque indicated.
Cheers, Quinton