KRH1326
Chief Petty Officer
- Joined
- Sep 22, 2007
- Messages
- 491
Hello All,
Replaced my 1987 175HP Crossflow with a 1997 175HP Looper. All switch overs have gone well, except for the tilt / trim cable, to my remote. The existing cable is a round, black, rubber plug with 5 wires... while the new motor has a plastic, triangular plug with 3 wires.
The harness was adapted, so that my existing wiring ( large round red plug could be used ) for the main system wiring. I have the other side of the remote plug ( black, rubber, round ) but need to know what wires I need to connect.
Any input?
Kenny
Replaced my 1987 175HP Crossflow with a 1997 175HP Looper. All switch overs have gone well, except for the tilt / trim cable, to my remote. The existing cable is a round, black, rubber plug with 5 wires... while the new motor has a plastic, triangular plug with 3 wires.
The harness was adapted, so that my existing wiring ( large round red plug could be used ) for the main system wiring. I have the other side of the remote plug ( black, rubber, round ) but need to know what wires I need to connect.
Any input?
Kenny