Top Snapper boat cover tool

[Redneck_Randy]

Has anyone tried one of these tools for removing the cover ? How well does it work ?

http://www.overtons.com/modperl/product/details.cgi?i=72146&pdesc=Top_Snapper&aID=601A2D&merchID=4006

Thanks
Randy

 

[Engine344]

Re: Top Snapper boat cover tool

Yes I have.....mine is made by Attwood (same idea) If used on fiberglass boat use a little PB Blaster with it and take your time. Problem I had was cover had satinless snaps, boat had aluminum snaps.....disimilar metal issue. However with some times and some PB Blaster you can work it out!

 

[Engine344]

Re: Top Snapper boat cover tool

Sorry another note.....PB Blaster can stain non waxed fiberglass and may make an oil stain on your cover.....WD 40 less issues but does not work as well? Trade off is yours! Good luck!

 

[Fireman431]

Re: Top Snapper boat cover tool

They work great, but the metal angle (for prying) that rests on the hull can cause marks. If you get one, cover all metal, except the hooked portion, with duct tape or use a rag under it.

Best bet is to lube the snaps up with Chapstick so they clip in & out like they should.

 

[Lion hunter]

Re: Top Snapper boat cover tool

Just another tip for easy snaps, threaded seams or leaking canvas: Go to an archery shop and get some bow string wax. Looks like a huge stick of chapstick. Works great for sealing canvas in the rain, zippers and anything else you can think of. I keep a couple of tubes laying around in the camping and fishing gear.

 

[Redneck_Randy]

Re: Top Snapper boat cover tool

Thanks all. I'll wax the snaps first and go from there.