Vinyl upholstery problem-corner

[MJVAUGHANS]

I have pulled as tight as I can and used heat already. This is actually the second time I have done it. The first time I pulled so much that I ripped the vinyl and could not salvage. I have it so tight in places I am afraid it may rip at staples in a few places again. The first time I stated on a straight side and worked toward the angle, the second time I tried to start with that corner and work out from there-little difference in the results. My vinyl does not seam to have stretch much, or not enough. Is there another way to do this? I may not be a skilled upholstery guy, but I have covered 10 other things in this boat so far and this sharp inside turn is kicking my butt. Btw: thank you for you help.

 

[jimmy wise]

hi, good evening. you need to pull staples and pull vinyl to top and bottom. the corners are fine. pull opposite the wrinkle. heat will help but you are close

 

[MJVAUGHANS]

I have pulled as tight as I can and used heat already. This is actually the second time I have done it. The first time I pulled so much that I ripped the vinyl and could not salvage. I have it so tight in places I am afraid it may rip at staples in a few places again. The first time I stated on a straight side and worked toward the angle, the second time I tried to start with that corner and work out from there-little difference in the results. My vinyl does not seam to have stretch much, or not enough. Is there another way to do this? I may not be a skilled upholstery guy, but I have covered 10 other things in this boat so far and this sharp inside turn is kicking my butt. Btw: thank you for you help.

 

[tpenfield]

I would try starting with the top and the bottom most point, based on your picture and work towards the sides from there.

 

[Woodonglass]

What are you doing on the back side at the corner? Any relief cuts or overlaps? Using any glued on sewfoam on the backside of the vinyl?