Water Presure Gauge Install

[J.T.]

I am wanting to add a water presure gauge to my 1994 Ranger/1994 150XRi. Does anyone have any advice the install before I run into trouble? Is this a project that a halfway handy guy can undertake? Any info on the subject would be much appreciated. Thanks in advance. JT

 

[gss036]

Re: Water Presure Gauge Install

I just put one on my 89 200hp, simple job. Just make sure you don't bind/kink your water line to the gauge and hook it up to the proper spot on the engine. This the tech support page for the pressure gauge for installation.<br /> http://www.teleflexmarine.com/cgi-bin/frameset2.cgi?site=gauges&type=int&link2=1047

 

[Perfidiajoe]

Re: Water Presure Gauge Install

I put one on my 1995 225 XRi years ago, a pertty straight foward job, no mysteries. One thing note your readings when you first hook it up & all is fine, so you can tell if something starts to change. Good Luck, Joe

 

[Silvertip]

Re: Water Presure Gauge Install

1) Buy the gauge. 2) Drill the hole in the dash and mount it. 3) Route the tube from the gauge to the engine. 4) Install the fitting in the engine. 5) Attach the tube at both ends. 6) Connect the gauge light wires to the wires that light the other gauges. 7) Go fishing.