water pump

[barnyard]

installing new impeller ect on apha one gen2.
​the rubber block on rear (propeller side) of case. is this installed with step up (upper drive) or down (toward prop) Thanks

 

[barnyard]

Same job, another question

Replacing impeller Alpha 1 gen 2. There is a plastic piece (3.5"x2.5") that slides into channel in upper unit. Part has a "x" molded into it and small notches on each side. Does "x" face forward or back and notches up or down? Also requested advise 12:52 pm earlier no responces. Please help

 

[barnyard]

Correction 11:52am

 

[Rick Stephens]

Doesn't matter.

I use a little silicon or 4200 to keep it in place.