I purchased a water separator (Attwood) today.
My question is pertaining to mounting.
I have mounted the bracket against the bilge compartment where the filter and bracket faces rearward towards the transom, I blocked off the holes that point towards the tank/pump and attached the fuel line to the arrows pointing towards the bulb/engine.
I assume this is what the arrows are for, I was able to start the engine and let it run but just want to make sure I have installed correctly.
My question is pertaining to mounting.
I have mounted the bracket against the bilge compartment where the filter and bracket faces rearward towards the transom, I blocked off the holes that point towards the tank/pump and attached the fuel line to the arrows pointing towards the bulb/engine.
I assume this is what the arrows are for, I was able to start the engine and let it run but just want to make sure I have installed correctly.