Latest activity

. . . . . .

I can easily clean it up before it goes back on a wheel.

HP rating on the boat ??

Dude , I know its not great but that rust aint bad compared to some I have seen . Honestly if that were mine Id tip a bit of oil in...

Not sure, do you all think it was caused by the dreaded cracked cylinder head that they're infamous for? I basically got it super cheap...

I already checked them......nice grounds and the voltage during cranking does not drop below 10.5V.....the situation is not better even...

check battery connections and other wiring to the starboard engine. if the voltage is low during cranking and is dropping, that would...

I totally agree with you, but the fact that when it starts, runs perfect.......?? Would it run perfect if the cap had problem? I mean...

Dude , I know its not great but that rust aint bad compared to some I have seen . Honestly if that were mine Id tip a bit of oil in...

How long was it sitting without oil in the cylinder?

I can easily clean it up before it goes back on a wheel.

What i could have done is use the trailer mater cylinder to puch it out- but I had already replaced with a new and wanted to rebuild so...

The brake if off tge trailer on a bench.

Yes

This boat is my first attempt ever at doing boat interior.