My Father has a 1996 90 Hp Johnson model #j90tleda and we are looking for new gauges and the Tach has warning light build into them and we are looking for the same type of gauges for this boat due to the face fading. The color of the face is red and we want to same color? Thank for any help.
I have a 7 invader 15 foot and I have some minor cracking on my gelcoat and I want to fix it and can I use bondo to fix some small chips in the gelcoat. I am going to use paint. thanks for some help.
I have a 1996 90 HP johnson I raised the motoro to mow under it and the next day I went to lower the motor and I hear the pump but it will not go up or down. How do I check the trim fluid? any help would do, Thanks.
I have 1975 90hp Chrysler. Here is the problem I ran the boat in the water for 30-40 min and it ran great. Then the problem occurred, it bogged down but did not die. When I got it back home I checked the compression and it was fine at 145lb, 150lb, and 145lbs. I took the carbs off and cleaned...
I have a 1975 Chrysler 90 hp and while I was timing it I got the timing at 32 degrees BTDC and my Idel picked up to almost 2000 RPM how do I back down the Idle now? The RPM was fine before I timed it.
I have a 1996 90hp johnson and spray deep crep in the engine and it was running a 700 RPM at Idle. I let the motor sit for 15-20 minutes and started it back up and it run about 700 RPM for about a minute and then sped up to about 1200 RPM and I had to turn the idle screw back down to 700 RPM...
Ok Heres the Problem, I have a 1996 90hp Johnson that has not been started since last summer. I got it to run and finish the old gas that was in the carbs. Upon attempting to start the motor I noticed that there was what looked like gas or oil coming from a hole that is on the top carb. the only...
I have a 1975 chrysler 90hp, I jts got it running aftre 3 years of sitting. It started right up after about 5 rotations of the motor and ran great. The question is what is the proper water temp that is coming out of the tell tail?
Or a round about guess. I checked it and it was 135-140 degrees.
I have a 1996 Johnson 90 HP and was working on the tilt and trim gauge for the motor and turned on the key to see if the gauge was working andI heard something that sounded like a fuse blowing and now I turn the key on and nothing happens. The Tach does not move and the warning buzzer that used...
We Have a 1988 bayhawk 180st and had some soft spotts on the floor and we cut out the floor of the boat using a circular saw set at 1/4 inch to 1/2 inch deep cut so we would not cut the stringers. we took off the floor and checked the stringers and they were solid as a rock but the floor has...
