So I got an I/O engine on my boat. My boat had a switch with the 2 purple wires. Unfortunately I got the one with a black wire and a black and yellow stripe wire. The purple one was there for show and did not work nor was it connected. I am assuming I should make a cut in the purple wire and...
So you are saying, that purple wire, needs to be cut and spliced, then in one side put it through one side of the purple wire to the switch , then the other side if I had the proper switch okay I get it now
So I have an inboard/outboard or stern drive, it is a sea ray 180 bowrider. I can't find the second purple wire that related to the kill switch. I bought the run/off switch but it was the black ground and the black and yellow. I thought it would do the same thing. I now need to replace a bunk...
Yes I am replacing the lanyard switch. I don't know where the second wire connects too. Is it the yellow red one or purple one? That is all I need to accomplish because it is back on
So the kill switch I'm replacing. I'm trying to figure out where would I put the actual black and yellow wire cuz I do not see another one with the other boat wires? Additionally, the original kill switch was purple wires with a purple and white wire as well.
So I have a new kill switch and it haves black for ground, and black/yellow for I'm guessing that goes to an ignition. My question is my old one is purple and purple/white what do I do? Is the black and yellow one go to the purple one and I know black goes to ground
