Well, I've been out twice more for about 5 hours each time. I'm going to check the pontoons this weekend and see if there is any water in the starboard toon.
I'll post what i find
I will check for cracks on the starboard toon for sure. But, the port side toon is holding air, so i'm sure it has no cracks. So if there are no cracks, is the water in the port toon just from condensation?????
So, i decided to check my pontoons for water. I opened the two 3/4 inch caps on the top resr of each pontoon and stuck a wood dowel in. They each made a water mark about two inches high on the dowel. The boat is on the trailer and the bow is much higher than the stern.
So, i put a siphon hose...
Well, another update.... I got the toon about 95% done before the July 4th weekend. Took it out for a shakedown cruise and then brought it back home to finish things up and fix the issues found during the shakedown.
First, the Yamaha 80 was idling too high to shift into reverse. Adjusted the...
YES!!!! That's it! Thank you very much! I just ordered it. That should solve all the problems of the world....or at least my current problem.
Now I just have to hook up the control cables and fuel lines....
I looked at the diagram you posted above and thought you were providing me with the wiring colors. I have been pulling my hair out tfying to get the main electrical working and it seems like I am just missing one link to get it done. Now i've been told I also will need a wiring harness that...
I know what the pin colors are and what they go to. But i dont want to cut wires and put pins on if there is a sub-harness that simply snaps into place. My 704 control box has the wires shown above. Is there aYamaha harness that the pins on the ends of the wires go into that then allow those...
I bought a 1997 (?) Yamaha 80 3 cylinder, 2-stroke, that dos not have oil injection. Along with this motor came a 16' long 10 pin main harness, a 704 control box and an analog Yamaha brand tach and trim gauge.
I know that the single 10 pin harness goes to the mating connector at the engine. I...
