Hi guys,
I've got a 13'6" wooden runabout a 1956 30hp Evinrude. I converted the motor over to a short shaft last week and well I ran the boat and by my GPS it will only run about 21-22 mph. With the motor as a long shaft it ran about 18-19 mph. The boat probablly weighs less than 300 lbs. I...
Hi guys, I rebuilt the carb on my 18 hp evinrude and converted it to a fuel pump using a 3 line pump (18-7353) and it seems to work fine. The only problem I have is I'm getting a little fuel leaking at the high speed needle adjustment. Its got new packings and I've tightened them down but still...
Hi guys, can anyone give me the part # for a fuel pump to convert my 1957 evinrude 18 hp motor to a single line? I was going to keep the dual line tank but found a hole in the bottom as I was sanding it to be painted. I just replaced ignition system,impeller, and rebuilt carb. Now all I need is...
Hi guys,
I need some help finding a " U joint boot for a Eaton Interceptor marine drive. The drive is on a 1963-65 Hydrodyne ski boat with Ford interceptor motor. Any one got any ideas where I might find one? I have ordered two but both would not work. thanks
HI guys,
I have a 1956 evinrude 30 hp that I bought last year. I just put it in the water yesterday and it would not build any rpm's at full throttle. It felt like it was under a load. I got it back to the house and the plugs had a small amount of fuel oil mix seeping out around the plugs. I...
