So it won’t start again according to the timing light and the marks on the fly wheel , it is in time . I have spark continually while cranking . I have replaced gas lines connectors , squeeze ball is hard . So I don’t know what else to do . I have posted a lot of infor
Action so people who know...
There is 120 both cylinders here are the books one is a parts book
The other thing I did tonight was I took off the fuel pump and just bypassed it to the carb manifold. And it ran again , ran like ****. Air screws on carbs are out 5 turns . At 3 or 3.5 or 4 or 4.5. Won’t run start die. I...
I don’t want to jump all over the place on this topic . But can someone post a picture or the book number that should be using. So I have a fuel water separator just before the motor. Gas is fresh . I am scratching my head a lot . I will post compression numbers
Thank you for the reply’s. No matter what I do I can’t get this to idle nicely or even good . It is a 2 stroke . lol. I looked under flywheel seal is not leaking . I have had the motor running and sprayed carb cleaner around motor looking for vacume leaks . Motor never sped up . The timer...
If the flywheel key was sheered wouldn’t it be out of time for the magnets are telling the aystem
When to fire properly ?
As for holding the key in for the primer , at this time the primer is not hooked up. I have to replace seal . Don’t is
Not on motor at this time .
Sorry I lost the page , I book saved it now . I was told it was a 2002 ???
So last year the motor was running rough. So I decided to buy the repair manual . I am
Mechanically inclined , so I also download a video from Brandon’s garage that shows you how to adjust the linkage back to factory...
Hello all, long story short, was told this was a 2002 Johnson . 50 hp bombider . The welsh plug is the only thing left for tag. I can add pictures if needed but here is a picture of the plug
