Recent content by davynep

  1. D

    OMC 400 Stringer Steering Shaft Zerk Fitting Stripped Out

    It is a '79 by the way. I am thinking of putting some JB Weld on it. Either that or I have to take the outdrive off again, which I just paid for and remove the steering shaft that I just had installed. When your greasing this Zerk, just below the steering shaft on the outdrive, you want to turn...
  2. D

    Can 2 onboard chargers run off one 110v plug?

    Re: Can 2 onboard chargers run off one 110v plug? Yup I am putting on a flush mount but I think I will pick up one of those three way shorties. That way I only have to chop the plug end of the three way splitter and replace it with the flush mount. I can then just plug the two chargers into...
  3. D

    Can 2 onboard chargers run off one 110v plug?

    I have a 10 amp dual charger for my 24v trolling motor deep cycle batteries. Then I got a 1.5 amp single charger on my starter battery. I was wondering if I can splice them both into one flush mount plug terminal? This way I would only have to run one extension cord for both chargers to get...
  4. D

    1979 OMC STRINGER 400: Seized steering shaft between the IH and Outdrive

    So I bought this boat about three years ago and always had it in fresh water. Recently though I was tempted by some friends to go crabbing out Half Moon Bay. After about 2 weeks the already difficult steering became locked up. The first day I was able to get it moving. I realize at this point I...
Top