Thank you,
his doesn't have the brass block, he has some little cinchy round setscrew looking device with only a nut on one side that doesn't pull back when throttling down. Yours appears to have a not on both sides of the brass block correct?
Thank again
Hello,
I'm trying to help out a friend with his boat and I'm wondering if anyone has a similar boat with the AQ271c 5.7. His throttle linkage to the carb just doesn't look right to me so I'm hopeful someone of you can share a picture of yours.
I know it's simple, but his is just strange.
thanks
so had a good talk with a buddy of mine and today he changed the water/fuel separator, added a spacing plate between the carb and readjusted the carb. He had told that he had already changed the filter but apparently not. That's the first thing I would have checked.
Anyway, the boat to 3400 rpm...
I know the carb dude tried rejetting but I'm not sure the size but it made to differance. I have the same props due to the fact that it ran perfect until it didn't. All this just makes no sense to me
here is a list
Cap, rotor, wires, plug, coil
Doubled checked firing order
set timing many times to be 100%
Distributer tested good, replaced dizzy
Fuel pump good
Carb rebuilt twice, new power valve, tuned by carb mechanic
Tried new carb
removed rev limiter
small fuel tank with new gas
Cleaned...
