FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I am looking for a tapping into a 'key switched 12v wire' and 'rpm signal' in the engine bay.
Just looking to confirm, but can I use the power signal (purple - location 9) from ignition control module for the 'key switched signal' and the tach signal wire (grey - location 11) wire off the...
I have a 98 Bayliner Capri 1850 with the APS hull and a upgraded 4.3L. I would estimate the engine should easily make 250hp. I have the alpha one 1.81 drive ratio and nauticus trim tabs.
Previous to the upgrades the stock 2bll 4.3L boat would run 47mph (gps) @ 4800 rpm on a $100 21 pitch...
I want to compare timing maps for the Alpha Drive vs the Bravo drive. part #s
861251T1 vs 861252T1
I found the one for the alpha's in the service manual, but not the Bravo. Any help?
I just had my motor rebuild, replaced the timing cover as you can only use them once. Everything has gone fine and dandy until I fired it up and I have a TERRIBLE high pitch squeal with the motor running.
I took off the belt and the noise was still present. I took off the dampner and it...
How much should my prop shaft move back and forth (in/out). I have a 01 Bayliner 4.3L with the Alpha Gen II drive. I couldn't find endplay specs in the manual.
