This is a 1985 or 86 25 Hp evinrude thru hub exhaust motor without shear pins mounted on a 16' flat bottom. I recently had the boat out and ran into a sandbar going a little over idle speed. I held the motor up to keep prop out of the sand until water was deep again. Began to accelerate to full...
Picked up a little 12' Sears Ted Williams v bottom boat to use on small ponds and lakes for duck hunting..it has a few small holes in the hull as well as a few spots on the edges that have worn thru. Its not fiberglass, kinda looks like PVC. Any idea of best way to repair/patch these spots? Was...
I have a 1968 6hp johnson that currently has a 2 blade prop. I use it for back trolling and trolling, but it struggles to move the boat with the two blade. I am trying to find a 3 blade prop that fits it.
I recently fried the EMM in my 75hp ficht. DFI says 99.5% of the time its a cooling issue/overheat. I removed the cooling tubes and blew thru them, they seemed very clear. Maybe just a electronics failure!?!?! Anyhow, I need to know what the best way to be sure the entire cooling system is...
