Hi all I just picked up a 2009 4stroke Honda bf2d 2hp outboard. I put it in some water and pulled the choke out and it started right up and idles great, but after you let it warm up for a minute and push in the choke it shuts off. If you try to rev it up with the choke out it shuts off. If you...
Re: 70hp mercury ignition meltdown (see pictures)
ok now Im really worried. I already ordered the new cdi stator 174-5454k1 This is the flywheel I have. will the stator I ordered work or do I need to get a new one again?
Hi all I have a 70hp mercury outboard it was running rough in the driveway. I turned it off and came out in the morning and everything is melted. trigger/cdi are melted and burnt spots on the stator. What would cause something like this??? I don't want to replace parts to have this happen again...
Hi all i just picked up a 1975 evinrude 15hp electric start. I am getting no spark. Can someone please give me a wiring diagram. Also what wires do i check with my ohm meter for the stator and the timing base?
Hi all i have a 1989 force outboard with no spark. What do i need to do to figure out the cause? I checked all wires and all seem to be connected correctly. Please help...
Hi guys i have a 1983 eska sears gamefisher 5 hp. I just pulled it out of storage Cleaned everything up and put fresh gas and oil in her. Now it will start but only at full throttle and it seems to be dumping gas out the exhaust. Would this just be a carburetor problem or is there a engine...
Hi guys i have a 1988 mercruiser 140 sterndrive. I just bought the boat it was not running. Bad gas. Carburetor accelerator pump not hooked up. I fixed these problems changed the oil. gave her an new coil, spark plugs and wires. Now she starts right up but and starting to hear a knock in the...
I have a 1975 mercruiser 120 inline 4cyl 2.5l. When i bought the boat the valve studs were pushing up through the head. I replaced the head and rebuilt the lower end. Now my problem is the nuts the hold the rocker arms on are vibrating loose. So i just replaced them all with poly locks. I took...
Hi i have a 1975 mercruiser peralpha r drive. I just bought the drive, when i got the drive i pressure tested the drive and it passed then i took the drive apart replaced the water impeller. (At that time i should of pressure tested the drive again and i did not). I filled the drive with fresh...
