FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
The nut that is on the crankshaft doesn't seem to thread properly onto the shaft... gets part way then becomes very tight... so I want to replace it. 1) how many threads per inch? I counted 20... 2) measured it at 3/4 x 3/8... will any hardware bolt suffice? Thanks
At various points in the carb linkage are these vinyl/plastic washers that dont seem to serve any purpose because they can flop around. See the pic I took.... are there supposed to be e-clips or something else to hold them flush to a surface? wondering.... thanks
Purchased a Seahorse and spent the last week getting her up and running! Here is what I did -new cylinder head gasket (has good compression based on the running tests I've done) -checked ignition coils/wires and set timing; both cylinders fire with nice blue spark -rebuilt carb after thorough...
