Just picked up a 1985 Johnson 8hp. I need a breather cover, and the piece that rides along the carb roller. It's the ramp that rolls along the roller as you advance the throttle. Any help would be greatly appreciated.
I have a 1992 Yamaha 3 hp model 3MSHQ. Where is it supposed to spit water out the telltale indicator? I see two holes on the back of the exhaust leg that it does that water out. Is it supposed to spit out at the back of the powerhead as well? Thanks.
I just bought this motor about a week ago. Cleaned out the fuel tank, petcock, and carb. All was well, and running good. Durring the past few days, I had some petcock problems (old junk plugging up). So I got it flowing good now. Im running marine gas with Lucas 2 stroke synthetic. Compression...
I need a good cowl, and a carb silencer cover for my 1996 Sears Gamefisher 3hp outboard. Already tried Sears, but they were long gone. Any ideas on where to get them? Thanks.
Are the Chrysler/Force 9.9/15 same bore and stroke as 7.5hp? Or is the difference in reeds, carb, and exhaust. I'd like to bump up to 9.9 if possible. Anybody ever done this on this motor? I know it has been done on the comcast 9.9/15. Thanks for any help.
I am looking for a .2 mfd condenser for my Evinrude Zephyr. Original part # is 201753. I was told one from an old 6cyl Ford may work. Don't want to mess up points, or coils though. Any help would be appreciated. Thanks.
Does anybody know which Sierra impeller I need for my Johnson QD16? I didn't know for sure if the one listed here for newer 10hp would work, or not. Thanks for any help.
Thinking of buying a Chrysler 20hp #2033 1969 electric start. Does this have coils, or ignition box? I will check it for spark when I look at it tomorrow. It's missing the tiller gear/shaft assembly on the motor side (half). Any thoughts on the ignition setup? Motor has 130# compression...
Plugs in the motor now are equivelant to Champion RJ18C heat range 18 My manual calls for RJ12YC heat range 12. Champion website calls for RJ14YC heat range 14. My motor does not have a thermostat currently. Thermostat was missing when I got it. I'm guessing that's why they put in the hotter...
On my Eska 15hp (Tecumseh powerhead), my fuel fitting leaks fuel (female end) when I disconnect from my motor. I can hear a hissing sound when I hold fitting higher than the tank (fuel being pulled by gravity back down into tank)? Primer bulb is mushy. I think o rings are sucking in air while...
Is there a way I can add a tachometer to my 82 Evinrude 50hp? I would like a round analog gauge to mount in panel. Anyone done such a thing on an older motor? What is a descent brand tach that will work for me? Thanks.
