Hello all...trying to figure out what this motor is trying to tell me.
It's a 1991 V6 150HP (edit...titled as 1991, actually 1990 E150STLESB from what I can find), VRO has been removed, running pre-mix.
New controls with the Johnsonrude adapter to allow use on the older motor.
It's been...
:confused: 2001 Johnson 25hp. I can't get water out of the TT when using the 'muffs'. I have tape over the 2 holes above the inlet on both sides per the OM. No problem when it's on the water. Any hints?<br /><br />Flustered flusher, <br />hc
Howdy all....been using my "new" '70 model 15' Deckette for a week or so now, and having quite the time getting it back on the trailer. The boat's hull is not a tri, but not a "v" either. It's more of a V that becomes nearly horizontal at the edges. The boat is very "U" shaped, with a very...
Got my '70 up and running, but it has no power past part throttle, and won't get anywhere near proper WOT RPM. Squeezing the primer bulb while running makes no difference. The motor seems to make good RPM in REV, but not in FWD.So far I've done the following....<br /><br />-Cleaned all 3 carbs...
My '70 Evinrude has been stored a few years. I went to start it, and after the checking most everything, put fuel to it and fired it up. It ran for about a second and I shut it down to check things out, but now the starter won't engage. I suspect it's something in the "selectric" shifter...
I've a 2001 25 Johnson on a 17' Lowe aluminum bass boat that acts like the hub is spun. Here are the symptoms and what I've done to date. It engages fwd or rev ok. It'll run at any throttle position for a while without any problems. After a few min's at hi or full throttle the engine revs...
