FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I'm thinking just hook them up to the starter solenoid as that's where they technically drew power from before? Via a jumper from starting solenoid to tilt solenoids.
I've got 1995 75hp 2 stroke. SN 0g1xxxx. Has solenoid tilt control. I pulled those, and replaced with relay system from a 2001 75hp.
So far all good. But I have 2 extra wires I need help identifying and where they go in the new setup.
2 red wires were connected to the lower solenoid headed...
I'll pull it tomorrow.
Bought this engine for $30. Replaced the points and condensers. Rebuilt the carb. Installed new plugs. Runs great and seemed good in the bucket but upon running in the lake I discovered this. Still only into it $80 so I've got some wiggle room on the gearcase to get it tip...
I've got a 1965 Sportwin 9.5hp.
It jumps out of gear at about half revs or 4-5 mph. At first I thought clutch dog but the prop shaft slides for and aft approximately ⅛ inch. Much more than in my 68 model.
That got me thinking that perhaps I've got a worn bushing, bearing, or seal that's...
My overheat alarm is squelching while running and when not running but having key in the on position. Trying to figure out the cause. Here's what I've noticed.
1. Tell tale squirts water at all times. Same temp, figured by feel of hand, as intake water.
2. Compression test has all three...
