I have a 1994 225hp .Came with 704 pinnacle mount.Want to change to a flush mount.Any idea what particular model I would be looking for?I originally had a Johnson on the boat.And it was set up with flush mount controls.
I recently purchased a 225 hp and is mounted. Covered and stored for the winter.did not finish all the hookups yet because I want to purchase a new flush mount control box.this came with a surface binnacle mount and won't work with my particular boat setup.wondering what model I need?
This motor is new to me.Haven't taken it out on the water yet.still doing some minor hookups.while running it with the muffs on/ while in neutral the prop is spinning.Is this normal???
I have a 21` proline walk around.1996.just wondering if anyone has any info on the going rate or price to have a new plastic enclosure with just windshield and sides done.anyone ever have a similar size boat done.thanks for any info. JOHN
What is the best way to remove the plastic lettering and pinstripe off the hull.then to polishing the boat hull.the sun has never seen this part of the boat.what would be my best bet to polish ...I'm afraid under the pinstripe and lettering will stand out over the rest of the boat...thanks for...
Just bought a 21 foot proline walk around with a 175 johnson.Both boat and motor are 1994.prop on there is a little banged up.just wondering what is recommended ???? Thanks for any info...
New boat to me this year.First time out with it and ran beautiful.Second time out sounded muffled at idle and just wouldn't run good.every time I laid on the throttle it bogged out.sounds like fuel issue to me.what are your thoughts????? Thanks John
Looking for replacement cabin enclosure for our 21 foot proline.we have everything but the starboard and port sides.what we have is pretty dirty and some broken zippers .....anyone out there know of or want to part or sell there enclosure...thanks for any help..'.John
Just picked up a newer boat .1994 proline with a 1994 175 johnson.haven't bought the manual yet.just looking for a little info.how much lower leg oil does this motor take.and also any spark plug recommendations.
Motor has always ran good/ starter has its good days and bad.Went out over the weekend started up /took kids tubing/ sat around for a couple hours/went to start up and got nothing.No clicking or anything at starter or selenoid.Put in new ignition today but nothing.what do you...
Cant get pin out of lift cylinder? any ideas anyone?????????? Want to remove off a spare motor i have.Will a 1980 fit a 1986? How about the lower unit??????Will most of these parts fit my 1986 90 hp??????????
I have a 1986 evenrude 90hp on my 18` renken seamaster center console.Wondering what is my best bet for the proper prop on this size boat and motor.Too many listed to choose......Thanks John///////////
Bought a 90 and got rid of the 150.Motor has been running good.but yesterday i went out and about 30 min. into the ride at about 3/4 throttle it just bogged down then died.Squeezed the primer ball and no hard pressure there but then built up again.Started right up and ran great.Watched the air...
