FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I have a 2005 hpdi 225 and I want to know what the pinouts for the nmea 2000 connection are? Is this the connector that the yamaha dealer connects there computer to when working on the motor? I want to make the cable that connects the engine to the lowrance red network.
Thanks for the help
sorry for the lenght. just installed a lcx-27c in my skeeter. i have a lms 480 on the front i want to network the two. of corse the cable is on back order from lowrance well i have an old blue cable so i decided to cut it open and ohm it out. i compared it to the blue to red cable here is what i...
I have a 1993 mariner mag3 150 hp. it is pumping water but seems to be running hotter then normal, personally i do not believe the thermostat. any thoughts
i have a 1988 evinrude 40 hp and i cant figure out how to disconnect the linkage to drop the lower unit. if the over heat buzzer has sounded is it to late for the motor, as soon as i heard the buzzer i shut it off?
thanks
jim cav
i have a 1993 mariner mag 3 150 hp and i had to replace the tempature sending unit and tempature guage. the sending unit is sits in a hole one on one of the heads. there was a gel or lubricant used to transfer the heat from the head to the sending. what is that gel or lubricant?
Thanks
Also i...
well i finally made up my mind, i am going to disable the oil injection system and mix the fuel my self. i want to use the boat instead of fixing the motor all the time. what do i need to do to disable the system. is there a way to fack out the sensor on the oil pump so i can keep the warning...
I have a 1993 mariner mag 3 150 hp i have just finished putting the motor back together, the second time the plastic gear has gone bad. is there a new version or up grade for this oil pump? or is it the same old pump being used.
If this happens again i am doing away with with the vro!!!!!!
well the motor is all apart and the crank is on the work bench. I have a 1993 mariner mag 3 2.5 liter 150 hp motorthis is the second time the plastic ring for the vro has gone bad the first time all i did was replace the plastic gear the first time this time i am going to replace all the parts...
