Recent content by jpdragon

  1. J

    Can I add power steering to 1998 1700SR Maxum?

    I have a 1998 1700SR Maxum boat and the steering is extremely hard to turn because it's manual and I am wonder if there is a power steering kits that I can replace? Other question is how much would it cost to change out the throttle, forward & reverse gear cable? Any help would greatly...
  2. J

    1998 Maxum 1700SR Steering is really hard.

    I have this boat 1998 1700SR Maxum, the steering is really heavy when turn? What is the problem? I don't think I have a power steering on this boat? Can I put one in?
  3. J

    Tachometer not workin on 3.0L Mercruiser. Where to begin?

    I have a 3.0L Mercruiser (Maxum 1998 1700SR). Bought last week and the tach is not working. Where should I begin troubleshooting? I had already repair the Speedometer gauge. I have a bad trim sender. Can the trim sender be repair or must be replace?
  4. J

    Clink..Clink..Clink..Gear Make this Noise! Why?

    I have a 3.0L Mercruiser (Maxum 1998). It's make a loud clink..clink..clink.. noise from the lower unit when I put in forward or reverse gear. What could be the problem? Sometime I have to repeatedly set Neutral -->Forward-->Neutral-->Forward then the gear kick in. I am attached a picture...
  5. J

    3.0L Mercruiser No Spark.

    I have Maxum 1998 3.0L Mercruiser. Ran fine two days ago and took it out yesterday to clean carpen and vaccum the floor but today didn't start. I check the spark ignition wire and didn't see any spark. Fuel pump to the carburator just fine. What could be the problem? Am I touching any wire that...
  6. J

    Speedometer & RPM not working.

    The speedometer and RPM meter of my boat is not working, can someone show me some idea to troubleshoot and get it fix? 1998 Maxum 3.0L Mercruiser 135HP. Thank you.:)
  7. J

    1998 Maxum 3.0L Mercruiser Leaking Oil. HELP.

    I took my boat out for a test today and notice the oil is leaking somewhere above the lower pulley. I have a 1998 Maxum 1700SR 3.0L Mercruiser 135HP. What would be the cause of this leak? What is the possible part name? Could it be from the 2nd picture below white color pulley?
Top