Recent content by jsaylor

  1. J

    over heats

    2001 Crestliner super hawk 1600 with 70 evenrude 2001 4 stroke. Just bout this boat, has a total of 36 hours. Don't know why but someone installed a dolfin and trim tabs, first time out when triming up at about 4k heat alarm comes on, took of dolfin and much better but still will over heat at...
  2. J

    suggestions for ladder for 2001 crestliner super fishhawk 1600

    I'm asking for recommendations for the ease of install and fitment
  3. J

    suggestions for ladder for 2001 crestliner super fishhawk 1600

    Any suggestions for a boarding ladder
  4. J

    Prop question

    Prop diameter is 11.1X11, noticed my cavitation plate is about 2 inches below the boat, do you think raising the engine 1 inch would increase my rpm much?
  5. J

    Prop question

    What brand 4 blade?
  6. J

    Prop question

    2005 crestliner pro angler 1650 50hp tldi nissan. Have a 11 pitch wot about 5200, at 25 mph, also have a 13 pitch wot 4800 rpm 29 mph. These are figures with two people in the boat, add two more adults and can't get on plane with the 13 pitch. It seems perhaps I should get a 12 pitch? or...
  7. J

    What torque for my prop?

    Thanks, I have two props that look identical, on muffs one sounds horrible in gear while the other sound fine. In the past on other boats I simple would hand tighten the nut the then tighten until the next place to install the couter pin, why would some say 25lbs and other sites hand tighten?
  8. J

    What torque for my prop?

    2005 Nissan 50 hp 2 stroke TLDI Some say don't torque the prop and others say 25 to 30 lbs. Manual states to securely tighten? (what does that mean?) I didn't torque my prop and had a bit of prop chatter? engine is new to me. Thanks.
  9. J

    Top speed?

    I'm looking at a Smoker Craft 162 spitfire 1998 with a 2019 mercury 4 stroke 50hp, worried it may be under powered, usually 2 people and would like to see 30mph, opinions? thanks
  10. J

    Ideas on a 1999 Sylvan 1600 Adventure

    Going to look at a1999 Sylvan 1600 Adventure with a 75hp 2 stroke, any ideas on possible cruising speed or top speed, I know much depends upon prop etc. just your thoughts. Any general thoughts on this model?
  11. J

    Thermostat impellor question

    thanks all, I'll check it at the lake. I seem to be having a difficult time finding the right pump and thermostat.
  12. J

    Thermostat impellor question

    The reason I'm not changing the impeller at this time is because this boat was dropped off at my home asking if I wanted to buy it so I wanted to give it a short test on the water first.
  13. J

    Thermostat impellor question

    I will replace the impellor after I go for a test drive, used a infrared gun at head and thermostat cover, I could also hold my hand indefinitely on head. Just want to go for a test drive before replacing impellor. Can muffs give a false impression on water pump working? I was thinking perhaps...
  14. J

    Thermostat impellor question

    Just picked up a 1971 Evinrude 60 hp model 60173c been sitting for about 3 years, started in a barrel, started instantly and ran perfect, not much if any water from exhaust. Removed a lot of bees hiding where the water exits. Put the muffs on and starter again, no water from exhaust but lots...
  15. J

    Listing to port side

    2003 1850 Crestliner, 115hp honda. Boat does list to port, would like to raise engine in hopes this would help, at this time running near full throttle and trimmed out a bit the cavitation plate is about an inch to a inch and half under water, cavitation plate sits about 3/4 inch below bottom of...
See more
Top