Recent content by jsferra1

  1. jsferra1

    Thunderbolt V Without Knock Sensor Basic Mode

    I have two issue that I know of ( and hope only two ). I have a 1997 5.7L Thunderbolt V Without the Knock Sensor,one issue is my Tach is NOT working I will start looking in to that this week/end the other Issue I have and it may be connected to the tach is Prior to setting the timing I put it...
  2. jsferra1

    Shift Cable Oooo No

    This week end I pulled the outdrive to repolace the Bellows, Shift Cable, U-Joints , Gimbal Bearing, Trim senders and Water pump. It started fine and then two screws for the trim senders one on each side would not come out and yes they broke , I do the water pump no problem, I do the U-Joints...
  3. jsferra1

    R&R Bellows and impeller

    Hello, I'm back :) I have an Alpha I Gen II, I will be doing the Bellows, Gimbal bearing , impeller and Trim Sender Kit. I was thinking about the U-Joints, that maybe I should replace them while I have the drive off along with the Gimbal seal. The reason why is I have no idea when any of this...
  4. jsferra1

    Base Timming mode or not

    Hello, I'm back, I have a 1997 5.7L TBI V (I think it is a V TBI any way) from what I can see I don't have the Knock Control module on my dist and since it is not there I assume I don't have one since I can not find any place in the manual that says it could be here or there it only has it...
  5. jsferra1

    1998 Merc 5.7L TB V can not find the timming mark

    Hello, I have a 1998 5.7L merc gm 350 TB V the issue I have is I can not find the timing mark on the block All I see ( not much) is a small spot that has one V in it and on the balancer there is so much rust but I can see where there is a line that should be the timing mark but there is no...
  6. jsferra1

    1998 LXI 236 Need pics and info

    Hello, I just picked up a 1998 LXI 236 and I need to re do the inside and I also need to build a new hatch for the eng. If you have one Pls. Pls. send me a pick of what it should look like the hing for the hatch where it is located and also the shocks for the hatch. I also need info on the...
See more
Top