So you use the small spacer with the press fit setup and have had no problems? The old spacers are thicker than the new is there any Benefit thicker vs thinner spacers?
Yes I realize the input shaft should use that same size bearings. I ordered bearings for the 1.50:1 heavy. Apparently I have 1.50:1 non heavy. I’ve got correct bearings now through local shop. On the press fit shaft I thought you’re not supposed to use inner spacer?
I have a alpha one I’m trying to replace the bearings in the upper on the drive gear u-joint shaft. My serial no is 0b496372 there is an f stamped by the serial no. That should make it 1.50:1. I even counted teeth drive gear 22 driven gear 20. Looked up part number for bearings for 1.50:1 ratio...
I’m replacing the bearing in my gimbal ring. I’ve got it pressed in but not sure how far to go there is a seal and spacer that go on bottom. I don’t know it the spacer is supposed to set flush with the bottom or what?
